Production Tools

Production Tools

Production tools are downhole tools and components designed to enhance the efficiency and effectiveness of the rod lift system. These include what many consider standard operating equipment such as on-off tools, TACs, and mud anchors, as well as newer innovations such as the Gas Separator and Slimhole TAC.

Type B TAC

The installation of a tubing anchor is a common and beneficial addition to every rod lifted well. Maintaining pull tension on the tubing string greatly reduces tubing movement caused by cyclical loading created during normal rod lift operation. The reduction of tubing movement enables the pump to consistently make a full stroke and maximize the efficiency of the entire rod lift system.

Having been around for decades and commonly known as a Baker style, the Type B tubing anchor may be placed anywhere within the tubing string and set to anchor to the casing wall. However, the most common placement is below the sucker rod pump, typically with a tubing sub between the two in order to allow space for a gas anchor on the bottom end of the pump.


Download brochure

Download paper


Slimhole Tubing Anchor Catcher

Slimhole TAC

In contrast to a standard anchor, the Don-Nan Slimhole Tubing Anchor can be deployed at any point in the well in relation to the perforations. The improved design minimizes solids buildup in the anchor, and the smaller OD drastically improves gas flow past the anchor.


Download brochure
Slimhole vs Type B Flow Comparison

Gas Separator
The Don-Nan Gas Separator is a packer-style separator designed to separate free and entrained gas from wellbore fluids before they reach the pump intake. The separation of gas from production fluid minimizes gas interference and gas breakout in the downhole rod pump, improving rod lift system efficiency.


Download brochure

Download paper

Shear Tool
For wells using fiberglass sucker rods, the Don-Nan Shear Tool is run above the pump to enable easy retrieval of rods. In the event that the predetermined amount of tension is exceeded when pulling the sucker rods, the Don-Nan shear tool’s tensile element will separate, allowing the rods from that point and up to be easily retrieved. The remaining rods and pump can subsequently be pulled from the well, ensuring the integrity of the rods.


Download brochure

On-Off Tool
The Don-Nan on-off tool connects to or disconnects from a rodstring, at any point, based on the location of the tool in the rodstring. The tool is attached directly to the rodstring where
the operator wishes to make the disconnection. The tool is then disconnected by turning the rodstring and picking up. The tool is connected by setting down weight on the bottom latch section and rotating the rodstring in the latch direction.


Download brochure

Download paper
Share by: